A humble attempt for a simpler3Doodler 2.0 stand, I personally searched Thingiverse for one and I only found the one I 'Remixed', most others that I found were for the original bigger 3Doodler, although I don't know if this is considered a proper remix, as I only took the loop/ring of polygons surrounding the pen, although it's perhaps the most important part :)

The rest of the model is mostly simple extrusions and bevels of the original loop/ring of polygons, I hope someone finds it useful as I did, filament used in pictures is recycled PET from blue bottles from:

http://www.re-filament.com/shop/recycled-pet-filament-from-bottles-bottles.html

Print Settings

Printer Brand:

BCN3D

Printer:

Rafts:

Yes

Supports:

Resolution:

0.3mm

Infill:

Notes:

3 top solid layers, 4 shells/parameters, 7 solid bottom layers (to lower center of mass), 20 skirt outlines with 0.0mm offset, 0.50mm extrusion width, retraction enabled, nozzle wipe disabled.

70mm/s print speed, 70% first layer, 75% outer parameter speed, 85% solid infill speed, 200mm/s x/y axis movement speed.

Nozzle temp @ 225c, bed temp @ 70c

Category: Tool Holders & Boxes