I needed a better way to store my pliers than just dumping them into the drawer of doom. I decided to capitalize on my functional pegboard builds and adapt a design to hold the pliers up and off my bench.

I used a previous design to start and then lengthen it. At 200mm or so wide, it's about as big as I could print in the orientation I wanted (pegs point up). I also took the time to properly center the 7 pegs so the holder can be placed right next to another for continuous hanging capability.

Monoprice

Maker Select Plus

No

Yes

200

16.5%

Infill can be whatever you want. The higher it is the stronger it'll be. I think I used 16.5% on Kisslicer.