Kitchen vent hood with mesh, external
TealMiniature4
AI找相似
打印配置(0)
模型文件(0)
0
0
0
发布时间:2026-03-14 14:47:29
0
0
000描述
标签
模型来源
评论(0)
The external vented part of my cooker range broke but the butterfly vent hinge was left intact.
I couldn't get a new one without having to remove the whole lot including messing with the through-wall parts so I made this one in TinkerCad.
It fits a 4" vent and is made to sit flush on the outer wall where the old vent exited and had enough room to allow for the butterfly hinge to move, open/close. It could be siliconed in place or screwed.
A piece of material mesh could be added to exclude smaller insects.
I used auto brim and 'thin tree' supports in Creality Printer. All the rest was standard K1 settings.
Fiddle with it, Im sure it can be improved upon.
Print Settings
Printer Brand:
Creality
Printer:
K1
Rafts:
Doesn't Matter
Supports:
Yes
Infill:
15%
Filament:
Elegoo PLASilver
Notes:
The photos are before clean-up and, frankly, I think my KE would have produced a better print, possibly in white (I have found the Elegoo silver to be a bit messy although their same-box gold is great to use. It's just what happened to be on the printer at the time!)
标签
模型来源
原设计地址: 点击查看
CC-BY-SA