Sith Holocron Display Stand
Bruno Phillips
AI找相似
打印配置(0)
模型文件(0)
0
0
0
发布时间:2026-03-21 12:13:09
0
0
000描述
模型来源
评论(0)
I liked @DarthExtruder's original stand for the Sith Holocron from Galaxy's Edge, but it was a little too tall for my display area. I liked the design of the base, so I cut it down, enlarged it to fit under the entire holocron, angled it a little and placed the Sith Empire symbol into it.
There are two versions, one with the symbol inset into the display and one with it raised a little. This is my first remix and serious mod of any design and I am sure there are issues, but it printed fine for me. :-)
Printing:
It is simple and straight forward. I used 20% infill, and .16 layer height, but it should print fine at .20 layers and any infill you choose.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3 Pro
Rafts:
No
Supports:
No
Resolution:
0.16
Infill:
10% - 20%
Filament: HatchBox PLA Any
Notes:
I used a resolution of 0.16 to get better detail on the symbol embedded in the display stand, but any resolution should work. It is not supporting a lot of weight so use whatever infill works for you.
模型来源
原设计地址: 点击查看
CC-BY