Anger-o-lantern
George Hall
AI找相似
打印配置(0)
模型文件(0)
0
0
0
发布时间:2026-03-12 02:27:05
0
0
000描述
模型来源
评论(0)
I thought it would be cool to have an "Anger" Pumpkin from Inside-Out. This is designed to be used with a Piezoelectric mister so that fog/smoke comes out of his fuming mouth. Enjoy.
If you do use it with a piezoelectric mister it seems there is no way to prevent him from "drooling" due to condensation in his mouth.
Print Settings
Printer Brand:
Wanhao
Printer:
Wanhao Duplicator i3 V2
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
0.2
Infill:
100%
Notes:
YMMV, but I printed at 30% infill and found it to leak under his chin due to the steep overhang. The walls are 2mm thick in most places so depending on what your wall settings are it may not make a difference.
Post-Printing
Add a Piezoelectric mister for cool vapor effects.
You can find piezoelectric masters for under $10 on ebay and amazon. you just fill this up to just under the hole at the roof of his mouth and drop the mister in.
Meshmixer
Category: Decor模型来源
原设计地址: 点击查看
CC-BY