I liked the original design, but was a bit unstable due to the very thin wall, also not allowing to use of ND filters.

You can use the holes to the top and bottom to secure the print to the camera using the same screw but is not necessary (it is a very tight fit).

( IMPORTANT )I had to file down the original mount on the inside to allow a little extra space, I didn't like how I had to "force" everything in place. You do not need to remove too much material and you can still use the same cameramount if wanna go back to the 03.

If you like this feel free to support me ( https://www.paypal.com/paypalme/NikaSte?locale.x=en_AU )