If you have any of the old 70's Mattel Electronics sports handheld games this is a replacement battery cover for them. It was designed off a Mattel Electronics Baseball game but they all used the same cover. Print it in the closet color filament you have to match your game and enjoy.

Note: I did have to print this with supports for the tongue to come out correct. I used supports every 1mm but you could probably get away with 2mm or 2.5mm spacing. Also I printed this in PLA and it is much stiffer than the original plastic the game housing is made of so be careful when removing so you don't break your game.

Print instructions

Category: Toys & Games Summary

If you have any of the old 70's Mattel Electronics sports handheld games this is a replacement battery cover for them. It was designed off a Mattel Electronics Baseball game but they all used the same cover. Print it in the closet color filament you have to match your game and enjoy.

Note: I did have to print this with supports for the tongue to come out correct. I used supports every 1mm but you could probably get away with 2mm or 2.5mm spacing. Also I printed this in PLA and it is much stiffer than the original plastic the game housing is made of so be careful when removing so you don't break your game.

Print Settings

Printer:

Prusa I3 MK2

Rafts:

Yes

Resolution:

20%

Post-Printing

To make it easier to remove from your game you may want to trim down the height on the catch on the tongue.