micro:bit croc clip keeper
Violet Mitchell
AI找相似
打印配置(0)
模型文件(0)
0
0
0
发布时间:2026-02-21 11:28:34
0
0
000描述
标签
模型来源
评论(0)
Works with a micro:bit v1 or v2. Note that the edge comesvery close to some small components 10 mm from the edge of the board, but shouldn't touch or interfere unless your printer's Z-scale is incorrect. As ever, take care fitting anything to a circuit board …
tiny guard piece to stop croc clips / alligator clips shorting out on your micro:bit. Designed entirely from the Kitronik mechanical drawings, as the official ones are useless.
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
0.2 mm
Infill:
15%
Filament: Filaments.ca Canadian Maker Series Low Sheen Tough PLA Black
Notes:
No supports, but you might want to enable bridging.
Model already has elephant's foot compensation built in.标签
模型来源
原设计地址: 点击查看
CC-BY-SA