This is a mounting bracket that allows you to hang your computer under a desk. You will need two nylon straps 25mm wide, sufficently long to fit around your computer and some hardware depending on your choice of configuration. Fits any standard 210mm wide chassis.

It can be used in two ways

1. Screw the main brackets (red) directly to the underside of your desk using suitable countersunk screws and then strap your computer to the brackets using two 25mm nylon straps. For those who rarely need to open the computer casing. Mount it and forget it.

2. If you frequently fiddle around inside your computer then this option might be a better fit.
   Strap the main bracket to your computer using two 25mm nylon straps and then hang the unit on hooks fastened to the underside of your desk. For this you will need to print the main bracket (red), the mounting loops (green) and the hanger hooks (blue), two of each. The mounting loops must be fitted to the main bracket using countersank threaded screws, nuts and washers. The nut and washer goes on the underside of the main bracket where there should be enough space for them. Dont be confused by the countersank hole on the underside of the bracket, just put the washer and the nut to cover it.

All holes are 5mm diameter.

Creality

Ender 3 Pro

No

Doesn't Matter

0.28

50%

Print with top side facing the buildplate. If you use support, use from buildplate only.