Simple Pocket Operator Cover
olivefloss
AI找相似
打印配置(0)
模型文件(0)
0
0
0
发布时间:2026-02-16 05:10:03
0
0
000描述
标签
模型来源
评论(0)
A simple snap-on cover for the great Pocket Operator case.
I needed something basic to cover up the buttons so they wouldn't get pressed in my bag. It ain't complicated but it helps a ton. The knobs stick out the front, but hey, the batteries stick out the back. Don't believe any battery will get wasted from the knobs turning but I could be wrong.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.2mm Layers
Filament:
Amolen PLAMarble-like
Notes:
If you're printer can handle it, I recommend printing it upright on the edge to reduce or eliminate using any supports. Try out a brim if it won't stick on its own.
I printed it vertically with supports to fill in the potentiometer holes, but I bet it would be fine without.标签
模型来源
原设计地址: 点击查看
CC-BY