Power Supply Holder

This holder is designed to hold a psu (power supply) to the back of a wall or to mount to furnitures or a piece of wood (see picture).

• The bottom holder fixes the psu vertical in place and enables quick exchange or access to the unit.
• The optional clamp will secure the psu vertical mounting.
• For long term usage there is an optional top cover - without unscrewing this cover from the surface the psu can't be moved out or changed.

Supported supplies

Works with power supplies with the dimension (120mm width + 50mm height and any lenght). Example is a Nunus 24V, 17A, 400W PSU for 3d printers.

Supply size (cut off)

The cutout are made 121mm width and 52mm height [PSU SIZE] so there is a little gap for easier insert of the psu.

Ideas?

Leave a comment for further ideas.

MakerBot

MakerBot Replicator 2

No

Doesn't Matter

100-200 Micron

10-25%

All parts are designed to print without any supports and to save as much material as possible while retaining an air flow. The infill can be based on the used material 10 - 25%. For strong material like PolyMax 10-15% is fine.

If you use a 3d slicer where you can manually place supports you can add them optional to the side plates where the screws are fitted.