Thrustmaster Cougar MFD replacement keycap
AlivePiston
AI找相似
打印配置(0)
模型文件(0)
0
0
0
发布时间:2025-12-02 22:04:51
0
0
000描述
模型来源
评论(0)
Replacement keycap for the Thrustmaster Cougar MFD.
You will still need the original membrane cap half of the button for this to work; this simply replaces the hard plastic keycap. The button face is slightly concave on this model.
Print Settings
Printer:
Monoprice Dual Extrusion w/ Duet Wifi controller upgrade
Rafts:
No
Supports:
Yes
Resolution:
0.1-0.2
Infill:
100%
Filament:
SainSmart TPUClear
Notes:
Printed 0.1mm@100% w/ supports, but 0.2mm will likely be fine. It's a ~15 minute print either way.
Printed in TPU just because it's what happened to be loaded in the printer when I drew this up. Any material should work fine, but clear filament will preserve the button glow.模型来源
原设计地址: 点击查看
CC-BY