This is a bracket I made that allows you to move the LCD Touchscreen to the front of the Anycubic Chiron. using the parts you already have. This is not a clip on bracket, but a strong permanent mount that replaces the metal back plate on the LCD case. For me the screen was inconvenient at the side taking up a lot of width, and hiding the SD card slot.

Anycubic

Large Size Chiron

No

Yes

0.2mm

This should be able to be printed with PLA, ABS or other strong material.

I printed this with eSun PLA+ at 210C and 70 Degree Bed Temp at 70 MM/s

Print face down with 10P6 Logo facing up. Print with supports as the screws are very short, so you will need to support the screw recesses.

The LCD cable is long enough to wrap around the control unit.

Have fun :-)