CAUTION: The PETG didn't work. After first use the plastic got soft and deformed. Better results are achieved with PLA that is annealed in place afterwards. 100°C for 1h in an oven with circulating air on. So far no yielding or softening!

A replacement handle for the moka pot of some friends. Printed in PETG.

Plus: The button of the cap to fit the handle.

Print instructions

Print lying on the side with support activated for the strongest print.

Use PLA and anneal it for 1h at 100°C in your oven, set on circulating air. Best if you put it in the oven mounted to the moka pot, so the important sections (those who are at the intersection of pot and handle) don't deform too much.