Shroud / casing / stand for the Rev.C OV5647 Camera for Raspberry Pi. Same sensor as in the original (v 1.3) Raspberry Pi camera, but with a proper lens.

More about this camera can be found here:
http://www.arducam.com/raspberry-pi-camera-rev-c-improves-optical-performance/

I bought mine here:
http://www.ebay.com/itm/281212355128?\_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT

Print instructions

Category: Camera Summary

Shroud / casing / stand for the Rev.C OV5647 Camera for Raspberry Pi. Same sensor as in the original (v 1.3) Raspberry Pi camera, but with a proper lens.

More about this camera can be found here:
http://www.arducam.com/raspberry-pi-camera-rev-c-improves-optical-performance/

I bought mine here:
http://www.ebay.com/itm/281212355128?\_trksid=p2057872.m2749.l2649&ssPageName=STRK%3AMEBIDX%3AIT

Print Settings

Printer: SUMPOD

Rafts: No

Supports: No

Infill: 50%

Notes:

Printed at .1mm layer height.

Post-Printing

Tapping

Apart from cleanup the only thing you need to do after printing is to tap the 4 screw holes in the casing with an M3 tap.