This design is loosely based on RafaelEstevam's customizable screw/nut clip (https://www.thingiverse.com/thing:1125726). It is intended to mount a tube, like a cardboard shipping tube, to the wall for use as a cat scratching post.

Print 2 brackets, and mount each to the wall with two screws apiece. Insert threaded rods through the bracket arm holes and through holes you drill through the cardboard tube. Secure the rods to the brackets with nuts & washers. I think I wound up using leftover Ikea hardware from...something.

Use a high infill setting for strength, because these brackets need to hold the weight of the tube covered in sisal rope, plus the cat!

Print Settings

Printer Brand: SeeMeCNC

Printer: Rostock MAX v2

Rafts: No

Supports: No

Filament: PETG recommended
 

Category: Pets