OP-1 iPhone Stand
barbara
AI找相似
打印配置(0)
模型文件(0)
0
0
0
发布时间:2026-01-24 05:09:58
0
0
000描述
标签
模型来源
评论(0)
So, the OP-1 is a great little sampler - among other things, and the iPhone is a great source for dumping things into the OP-1...YouTube, Dropbox access, whatever. I thought it would be nice to have the iPhone right above the OP-1 for quick playing and triggering.
What I really wish was that the iPhone could spit out MIDI to the OP-1 without power complaints...now that would be really cool.
These little guys act as a stand, tilting the OP-1 up just a bit, which I like, and securely holding your phone, including a small case like I have here.
For the big 'plus' models, you just clip between the knobs shown, for smaller phones, just bring it one knob set to the left. Easy. Might hold some other phone models, but I've only tested our iPhones. Feel free to flame me about iPhones. Ug.
I included some CAD exports if you want to tweak it or start over.
Enjoy!
Print Settings
Printer:
MP Select Mini v2
Rafts:
No
Supports:
No
Resolution:
.175
Infill:
30
Notes:
Easy flat print. Nothing too exciting here.
Print a pair obviously. Most printers should hold a pair of them at once. Even my little MP [Select Mini](https://www.amazon.com/Monoprice-Select-Mini-Printer-Assembled/dp/B01FL49VZE?dchild=1&keywords=select+mini&qid=1617126873&sr=8-1&linkCode=ll1&tag=thingiverse09-20&linkId=ba6d823cc70a0752a3085dc73b0f1929&language=en_US&ref_=as_li_ss_tl) does.How I Designed This
Rhino
Just quickly put it together using Rhino. Measured the OP-1 and roughly measured the iPhone.
Extruded and then rounded off a bit.
标签
模型来源
原设计地址: 点击查看
CC-BY