32mm Diameter 

Minimum hight 38mm → adjustable up to 60mm 

You can use these little riser feet for nearly everything you want. I use them to rise up my filament storeage a little bit to hide some cables underneath it.

Quick and easy print. Very stable. 

I used M5 Heat-Inserts and M5 x 25 Hex-Screws. You can use shorter screws if you don't need the fully hight of 60mm.

After printing both parts: Insert M5 Hex Screw into the bottom of the outer part.                                                                      Insert M5 Heat-Insert into the hole of the inner part.

I used 2K Epoxy-Resin glue for it. 

Tipp: For a perfect lineup between both parts, just press or glue in the heat-insert first, then screw the hex screw into the heat-insert. Attach some glue to the screw-head and put the parts together till the screw head reaches the bottom hole of the outer part. Let them rest there till your glue is dry. Finish !

To attach the feet to a surface you can use 3m double-sided tape or super glue / 2K Epoxy

Printed in wood colored PLA+ 

0.2mm Layer hight  

3 Perimeters and 20% Gyroid Infill