A large rounded orange fruit.

No

No

~0.1-0.3 variable

Fruit:

Sketch fruit profile using splines, then partial revolve 15 degrees into a solid. Fillet outer edges and circular pattern 13 instances into full circle. Combine all bodies. Fillet inner seams with variable lengths such that outer part is smoother. Split body near bottom to allow supportless printing. Join a disk to the bottom to fill any holes.

Stem:

Sketch profile of stem bottom using a pentagon for construction of splines. Sketch on 90 degree plane a gentle curve. Create plane tangent to the top of that curve and sketch a smaller version of the stem profile. Rotate the smaller profile a small amount then loft the two profiles together. Extrude the bottom part of the resulting body to act as a peg to insert into the fruit. Move the stem and cut a hole with the peg part into the top center of the fruit. Scale the peg down a tiny amount to allow fitment tolerance of about 0.2mm.