Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

 The Model is 200x200mm in size. You can change the X and Y but Z can remain the same.

 You may print at higher layer heights below the Min Depth of 0.48mm

 Actual Depth is 4.6mm

Filaments Used:

PLA BambuLab Basic Red Transmission Distance: 4

PLA BambuLab Basic Black Transmission Distance: 0.6

PLA BambuLab Basic Beige Transmission Distance: 8

PLA BambuLab Basic White Transmission Distance: 5

This print uses 4 unique filaments. Substitute as needed.

Swap Instructions:

Start with Black

At layer #17 (1.44mm) swap to Red

At layer #21 (1.76mm) swap to Black

At layer #29 (2.4mm) swap to Beige

At layer #47 (3.84mm) swap to White for the rest.