pythagorus mug
Alec Johnson
AI找相似
打印配置(0)
模型文件(0)
0
0
0
发布时间:2026-01-12 08:27:19
0
0
000描述
标签
模型来源
评论(0)
A remix of the pythagorean cup by pythagorus. is functional albeit a bit slow.
when printing with supports you have to make sure that it doesnt generate supports inside the handle. this will block the flow of the water coming out. to do this in cura you have to use the support blocker. this will generate a cube that cura will not generate any supports in. just place a couple in the handle and your good.
Print Settings
Printer:
anycubic
Rafts:
No
Supports:
Yes
Resolution:
.1
Infill:
20%
Filament:
polymaker plawhite
Notes:
when printing with supports you have to make sure that it doesnt generate supports inside the handle. this will block the flow of the water coming out. to do this in cura you have to use the support blocker. this will generate a cube that cura will not generate any supports in. just place a couple in the handle and your good.
标签
模型来源
原设计地址: 点击查看
CC-BY