Fair warning: This was a tough print. I was using up old filament, so that probably made it harder than necessary, but still. There are a LOT of overhangs that kept curling up and causing the extruder to collide with the print. I had to use a brim, and increase z lift during travel, and it still didn't come out great. Good enough for me though.

This lamp base is designed to fit this pendant lamp kit. The opening is 46.5mm and should be fine for fittings up to that size, so long they have a lip to rest on.

The bulb is LED and generates next to no heat. I'd be wary of using any kind of incandescent bulb in any case, but definitely don't do that with PLA

This was designed in OnShape