A model of a lighthouse on a stormy night, created using HueForge

Print at 100% infill with a layer height of 0.04mm with a base layer of 0.24mm. (The 0.04mm layer height sounds scary, but give it a try! This layer height was not officially supported with my printer and a 0.4 mm nozzle, but you might be shocked at what your printer is capable of! The reason for such a small layer height is because of the relatively low TD filaments I had on hand)

The Model is 200x200mm in size

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Green Transmission Distance: 4
PLA BambuLab Basic Gray Transmission Distance: 2
PLA BambuLab Basic Jade White Transmission Distance: 5
This print uses 4 unique filaments

Swap Instructions:
Start with Black
At layer #16 (0.84mm) swap to BambuLab Green
At layer #25 (1.2mm) swap to Gray
At layer #29 (1.36mm) swap to Jade White for the rest.