Extremely inexpensive stringing test
cyber_forge
AI找相似
打印配置(0)
模型文件(0)
0
0
0
发布时间:2026-01-28 22:45:23
1
3
000描述
标签
模型来源
评论(0)
This is a very simple, inexpensive, and fast-to-print stringing test.
It takes 3-4 minutes to print with a printing speed of 70 mm/s and a travel speed of 175 mm/s.
The gab is about 3 cm wide.
As a bonus, here are my retraction settings in PrusaSlicer for my Anycubic Kobra 2 with ESUN PLA+:
| Printing temperature | 207 C° |
| -- | -- |
| Use ramping lift | yes |
| Maximum ramping lift | 0.9 mm |
| Ramping slope angle | 1° |
| -- | -- |
| Retraction length | 2.5 mm |
| Retraction Speed | 65 mm/s |
| Retract on layer change | yes |
| Wipe while retracting | yes |
| Retract amount before wipe | 70% |
I found out that at the end the "Ramping slope angle" helped with stringing the most (try to keep it low), besides the nozzle temperature of course.
标签
模型来源
原设计地址: 点击查看
CC-BY