Door Clothes Hook
Margot Horvat
AI找相似
打印配置(0)
模型文件(0)
0
0
0
发布时间:2026-02-10 21:56:50
0
0
000描述
模型来源
评论(0)
This is a clothes hook that can be screwed to the back of a door with a basic wood screw. It has a countersunk screw hole for this purpose, which is slightly angled for better force transfer.
The edges of the hook are also filleted to prevent the edges of the print from inadvertently scratching you when you go to throw your jumper over it.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
No
Resolution:
0.28
Infill:
25%
Filament: Any PLA White
Notes:
I would recommend at least a 1.2mm wall thickness to ensure strength under tensile load. Using a 0.4mm nozzle, that would be 3-4 perimeters. 25% infill seems to be the sweet spot, but you could probably stand to go lower, providing you have enough perimeters.
If you want super-smooth surfaces, enable ironing in your slicer for the top layer, but that's optional.模型来源
原设计地址: 点击查看
CC-BY