A few years back my dentist insisted that I start wearing a "Nightguard". The storage box that came with it is fine, but I wanted a couple more for Travel, Backup, etc.

This is my design.

When I print it though, I set the parameters to print with "NO BOTTOM". That way whatever "Infill Pattern" I am using gives the box some character when it is removed from the bed.

This also helps with bed removal, less filament in contact with the print bed.

Print Settings

Printer Brand:

TEVO

Printer:

Rafts:

No

Supports:

Resolution:

.25mm

Infill:

Filament: Inland PLA Any

Category: 3D Printing