I found some LED tea lights on Amazon that could be remote controlled, and I decided to remix the Ghost body to hold the new LED. This should work with any 30mm wide round LED light.

It will friction fit snug into the dial, and there should be no friction when sliding into the body front. If it is too tight fitting into the body front, just sand it down a bit, otherwise it's difficult to remove the LED when you need to change the batteries.

This is a remix to fit the following model: https://www.thingiverse.com/thing:747305

Print Settings

Printer:

Creality CR-10

Rafts: 

No

Supports:

No

Resolution: 

.2

Infill:

15

Category: Props