6" Threaded Riser Extension for BORA's Centipede collapsible work stand system. Threads directly to work stand and raises worksurface from 30" to a more comfortable 36". Extension is compatible with factory attachments and fittings.

You will need to print nuts for every extension, which you can find at the link below. Unfortunately, you cannot re-use the small orange nuts that came with your stand - BORA did some very strange scaling with those, so they do not fit standard threads.
https://www.thingiverse.com/thing:4805290

OR! You can avoid the nut altogether and use my direct thread-on cap, which is available in either a knurled or a smooth finish.
https://www.thingiverse.com/thing:4762874

OR! You can choose to print threaded "P-Caps" to replace the corresponding factory parts:
https://www.thingiverse.com/thing:4762963

Donations appreciated! Your donations help make my functional designs possible.
 

Notes: 

Prints without supports. Increase to 5 perimeters, and infill % can be set low.

Recommended print material is ABS/ASA or PETG (shown)