Inspired by the wrench by @OfficialAceFrehley, I wanted to give this as a gift to a friend who would appreciate the usefulness, but also something a little cheeky. The intent of the design is to be suggestive enough to raise an eyebrow, or perhaps a chuckle, but not enough to raise suspicion among those not keeping an eye out for such things.

There are working (although a little tight) M5, M6 & M8 hex grips in this tool. All the openings are labelled and the shaft says "TOOL" on both sides.

Great gift for friends.

The design prints very nicely without any supports. Shown in the pictures in blue PLA, but would also work nicely in any other materials I expect.

Hypercube

No

No

0.25mm

20%