A printable Hatch / Canopy for the AeroScout
Updated the Back piece (I forgot how much of a pain gluing magnets were) you now load the magnets from the other side.

Creality

Ender-3 S1 Pro

Yes

Yes

0.20 layer

3-5 %

The "Back" is printed magnet hole down with a 3-5 mm brim. (It helps with alignment)
The "Front" is printed with what is the back of it down.
The "Canopy" is printed is vase mode 2 bottom layers
The "Vents" is printed front (Flat side) down, 1 perimeter, 0% infill, brim and supports as needed.
Front and back are printed with 1 perimeter and 3-5 %infill 2 solid bottom layers.
Print like pictured.

On the version with the vent I cut the thin part with a rotary tool and hot knife. There are lines on the front of the "Canopy" and top of the "Front" to help with alignment.

There wasn't a full Hatch/Canopy on here, All done in Tinkercad.