Chimera/Cyclops mounting system for the SmartCore. Allows for 18mm inductive or other round probe to be installed along side the Chimera/Cyclops hotend.

Print at your desired layer height with at least 50% infill, for the actual mount you will want to print using support, I used cura for slicing, with "touching bed" support with the unit upside down and the upper rail touching the bed, feel free to experiment.
Attach the mount bracket to your head pieces in place of the original hot end mount, with the "rails" facing out, the grooves should be near your X rails. Using an M3 tap, tap the 2 holes in the right brace of the hotend mount and the 2 vertical holes. Attach the mount to the mount bracket using 2 M3x10 screws and nuts, through the grooves, and 2 M3x 10 screw in the top to adjust height as needed. Attache the sensor mount to the right hand brace using a M3x10 in the upper hole and an M3x5 in the lower hole. Install sensor, and Chimera/Cyclops using the upper 3 mounting holes with M3 screws and washers. Calibrate and enjoy.