Remix of "Hyperpixel 4.0 touch and Raspberry Pi 4B case (with Prusa MK3S bracket)" to fit UCTRONICS Raspberry Pi Touchscreen and add a fan.

This project involves 3D printing an enclosure and mount for the Raspberry PI 4, fan, and Touchscreen added to my 3D printer. And the steps involved to install and configure Octopi to control the printer and run on the LCD touchscreen display. The “OCTOSCREEN” plugin is used to show Octopi on the LCD.

You will need the following Hardware:
Raspberry Pi 4
30mm 5v fan and mount screws
40 Pin GPIO 1 to 2 Micro Expansion Board
UCTRONICS Raspberry Pi Touchscreen, 3.5 Inch
5v power supply
USB A male to USB B male cable.
4x 3mm standoffs (about 20mm long - to mount PI)
2x 3mm x 8mm screws (to attach mounting bracket)
3D printed case

see YouTube video for instructions: https://youtu.be/qBcfaF-Y7xQ

Custom Build

No

No

600

20% cubic

print at .2mm layer height or better, 60mm/s speed or slower, any material should work. no supports needed.