Chicken feeder that I made. The lid is placed on top to keep the chickens from flinging the food out of the bowl. I simply glued mine to the top to keep it from moving around, though there are locator tabs on it, but it won't hold it down just locate it onto the bowl. Stand is just to get it off the ground a couple inches. There's grooves in the bottom of the feeder to keep it from rotating on the stand. Tube is for the feeder, it will gravity feed once filled. I made an extension tube just to allow for more food and was limited by my Z height on the printer, you could just scale the regular tube if your printer has more room. I also believe if you have any 2" pvc laying around you could just use that as well. 3" would be slightly too large, main hole in the feeder is Ø3"

Creality

Ender 5

No

No

.2

20%