thanks to CPT_Spekkie and Adinin for helping me with feedback :)

i added the .f3d file for thoose willing to make personal changes. IF you make something and put on thingiverse please write my name as original author :)

please always read version reports and use appropriate versions

made this case for a raspberry 3 for AM8.
there is access to audio, HDMI, power and SD card and GPIO against the extruded frame.

there is also an cable duct for use between rasp and electronic case.

needs following:

1pc thumbscrev M4 (self tap)
3pc M5 screws 10mm (4pc if you decide to use the duct)
4pc 2.5mm screws and nuts

keep in mind that the screws for the side to the frame needs a smaller skull sinces the GPIO ports may be in the way.(should be fixed in V5)

printed with supports, my rasp fitted perfectly after i went over the contact holes quickly with a knife to smooth edges.

will be work-in-progress till someone else printed and gave it "ok"

2017-06-19
Version fix:
in V4 alot of fitting was made, made the holes larger for fastening to frame, made the holes for rasp screws coned so they dont collapse during print

2017-06-20
V5, added more space to the powerjack for thoose using phone charger cables.
V6, forgot to remove a small part when i extruded the case.
lid V3 updated so it fits V6

made an cable hider for use between the electornic case and the raspberry. the network cable goes inside the housing and out on the back where the small hole is. have not tested this yet.

there is a cablehouse for thoose using corners from AM8 project. its its 4cm to be put between rasp and electronic case

Doesn't Matter

Doesn't Matter

20