Summary

This is a remodel of another case found here on thingi. I modified it to show off the camera module more and change some clearances to fit better after printed on my ender 3.

There's also a version (v.3) that is connected between the top two corners to increase the stiffness around the top right corner of the case. This is great in PETG or other things with better strength but I suspect that pla might crack when putting the phone into the case. Version 2 should be no problem.

If you are getting the file into your slicer and it says something like, this is too large for your build volume or something then try making the model 10% scale. I don't know exactly why but sometimes the size gets multiplied by ten and that is obviously a problem.

for scaling, the model should end up being 75.6 X 155.99 X 11.34 mm