My partner is an orchestra teacher and their birthday is coming up so I wanted to get something they could put in their classroom. As such I had to swap statue parts since like most things art the original statue was in the nude. I created two versions one is just the base statue and the other is specialized to print better on my CR-10.

The basic models are the Dancing Girl either
https://www.myminifactory.com/object/3d-print-dancing-girl-107761
https://www.myminifactory.com/object/3d-print-dancing-girl-43302
or
https://www.thingiverse.com/thing:2522780

The Violinist
https://www.myminifactory.com/object/3d-print-the-violinist-or-allegory-of-music-103796

Two Lions with Twisted Columns and Bud-Capitals
https://www.myminifactory.com/object/3d-print-two-lions-with-twisted-columns-and-bud-capitals-62866

Peace and Love, Canary Wharf
https://www.myminifactory.com/object/3d-print-peace-and-love-canary-wharf-3588

and

Violin Miniature
https://www.thingiverse.com/thing:4068962

Creality

CR-10

Yes

.2mm

5%

Print speed should be decreased to 50mm/s or slower upon reaching the bow as it is a very spindly and prone to failure my first print failed here but It takes about a whole roll to print this so i just let it continue. I will probably snap it off and replace it with another one if need be.