This is a simple design for a small cable clip that can be mounted on most any surface. It has a 8.85mm diameter opening to pressure fit a larger cable and a smaller 2.7mm opening along the inside length to easily push smaller cables through.

Has a flat plate to use for mounting with hook & loop, double-sided-tape, or other method.

It is a lightweight design that prints quickly and uses very little filament.

Quick Note

This was primarily designed to fit a 3.5mm audio extension cable under my desk that was 8.2mm in diameter, so it may not fit all cable sizes without modifying the diameter of the opening. Make sure you measure you cable sizes carefully first.

Dimensions (WxHxD)

18.2mm x 18.2mm x 25.8mm

Cable opening diameter: 8.85mm