After trying numerous 3D printed standees for Gloomhaven and finding I was dissatisfied with each in some small way, I decided to make my own.

Features:

• Room for 2x 12mm dice.
• Two "chit" slots for small modifiers cardboard tokens.
• One large slot for a cardboard standee.
• Hex is sized to be slightly smaller than Gloomhaven hex spaces (35mm from point to point, 31mm from edge to edge).
• Slots for cardboard have slightly raised "teeth" to allow smooth insertion of the cardboard figure without marring the surface. Tested with second printing of Gloomhaven.

Other standees were too large and wouldn't fit well with each other on the game board, wouldn't hold two dice, or wouldn't grip a cardboard token right (too loose and you can't lift by the standee, too tight and you damage the cardboard).

This design was inspired by all the rest and has been tested over multiple game sessions.