I designed this pin board because I was tired of always sticking them to a cork board where they where covered by important papers, or on a backpack where they might fall off. Now all my pins have there own space and can be displayed on a cool cat! All you need to do to use it is to push a pin in and the friction of the infill will hold it in place!

To make the model work, you MUST use:

• 3D honeycomb Infill

• 35% infill

• 0 top layers

(once you take off a pin, there might be a small hole in the infill where the pin was)

IF ANYONE HAS ANY IDEAS FOR A DIFFERENT SHAPE, POST THEM IN THE COMMENTS!!!!!!