🔧 Assembly Guide: Ping‑Pong Launcher (Craft Prop)
⚙️ Parts Needed
-3D‑printed launcher body
-Wooden craft clothespin
-Long rubber band
-3 ping‑pong balls (ammo)
-Super glue
 
🪛 Step‑by‑Step Build
Attach the Clip

Super‑glue the wooden clothespin flat along the back mount near the handle.
Let it dry completely before adding tension.
Add the Rubber Band

Wrap the long rubber band around the grooves at the ends of the boom poles.
Stretch it back toward the clip — this will act as your launcher band.
Load the Ammo Holders

Place rubber bands around the pre‑made slits along the top rail.
These bands hold the three ping‑pong balls securely in place.
Ready to Fire (Toy‑Safe Use)

Pull the rubber band back.
Clip it into the clothespin.
Press the clothespin to release — launching the ball forward.
 
🧠 Tips
Keep tension moderate — it’s a toy launcher, not a weapon.
Use lightweight balls only (ping‑pong, foam, or 6% infill on modeled balls).
Avoid aiming at people or pets.
For smoother launches, check that the rubber band isn’t twisted

MAY BE CUT UP AT OWN RISK into multiple parts. Not for small printers!