Eiffel Tower FDM printable
byte_fine
AI找相似
打印配置(0)
模型文件(0)
0
0
0
发布时间:2026-08-05 02:19:11
0
0
000描述
标签
模型来源
评论(0)
Intro
Its the Eiffeltower not much to say other than this model can be printed with your glorified gluegun aka FDM printer like a Ender oder Prusa.
Printsetting
| Scale | its 220mm, 240mm upscale show be fine |
| Layerheight | 0.2 or 0.3 (photo is 0.3) |
| Perimeter | 2 or more |
| Infill | does not really matter, i left is as 10% Gyroid |
| top layer |
0.6mm+ so 2 for 0.3mm or 3 for 0.2 layer height |
| bottom layer | same as top, but more wont hurt |
| Supports | none, but a 5mm brim helps if you have warping |
Postprinting
- remove the brim, if any, with a hobby knive or deburring tool
- remove fine stringing with pulsing a small torch (like the this used for Crème brûlée)
- torch the large arc's and push it in if you have weak cooling.
If your Extruder sucks, buy one from a reputable China vendor like
(They have better Extruder, but these require custom print heads and only work as direct drive)
Or feel free to buy from local 3d Vendors (see voron Discord), Amazon may not be the best place.
标签
模型来源
原设计地址: 点击查看
CC BY-SA