Was super thrilled to finally thrift a Prometheus, but I was kind of bummed that it had no front handle, making it super annoying to use. It is actually decently sturdy, from my testing, withstanding more than enough weight than needed. This is not meant to look beautiful by any means; it is simply a replacement. I will probably clean the design up a little in the future, and make it look better.

PRINTING:

Material: has only been tested with PLA

4-5 walls 15-20% Infill

Part is pre-oriented

HARDWARE:

(1x) 5/16 x 3.5-inch bolt

(1x) 5/16 nut

ASSEMBLY:

Just put the bolt through the carry handle hole, (either direction works), then put the handle through the bolt and thread the nut on (see pictures)