Robotics Car Chasis
GentleRod
AI找相似
打印配置(0)
模型文件(0)
0
0
0
发布时间:2025-09-16 03:48:11
1
0
000描述
标签
模型来源
评论(0)
This is a 3D-printed robotics car chassis with mecanum wheels, designed for makers, hobbyists, and students who want to build smart robotic vehicles.
The chassis supports Arduino, ESP32, and Raspberry Pi controllers, making it suitable for projects such as:
Obstacle avoidance cars (with ultrasonic sensors).
Remote control cars (Bluetooth/Wi-Fi).
Line-following robots.
AI-driven cars with computer vision.
Features
Omni-directional movement with 4 mecanum wheels.
Battery compartment for 2× 18650 cells.
Mounting slots for motor drivers (e.g., L298N).
Front cutouts for ultrasonic distance sensors.
Top section for breadboard or controller boards.
Recommended Print Settings
Material: PLA or PETG
Layer Height: 0.2 mm
Infill: 15% - 30% (For strength)
Supports: None
Bed Adhesion: Brim recommended
📄 Full assembly and usage instructions are included in the attached PDF.
The chassis supports Arduino, ESP32, and Raspberry Pi controllers, making it suitable for projects such as:
Obstacle avoidance cars (with ultrasonic sensors).
Remote control cars (Bluetooth/Wi-Fi).
Line-following robots.
AI-driven cars with computer vision.
Features
Omni-directional movement with 4 mecanum wheels.
Battery compartment for 2× 18650 cells.
Mounting slots for motor drivers (e.g., L298N).
Front cutouts for ultrasonic distance sensors.
Top section for breadboard or controller boards.
Recommended Print Settings
Material: PLA or PETG
Layer Height: 0.2 mm
Infill: 15% - 30% (For strength)
Supports: None
Bed Adhesion: Brim recommended
📄 Full assembly and usage instructions are included in the attached PDF.
Leave you suggestions down below for me to improve and fix.
The Flaws are: Breadboard cutout is too small.
标签
模型来源
原设计地址: 点击查看
CC BY