I wanted a better & cleaner way to mount my CPAP hose and the toolhead wiring, and this is what I came up with.   Uses a single 8" zip tie to hold everything in place once you screw it into the aluminum brace.

You'll need:

• ABS or ASA filament  (PETG will barely work if your chamber doesn't get too warm)

• Long zip tie

• 2x - M3x6 Countersunk screws

Print settings:

• 0.2 (or less) layer height

• 3 walls, 20% Gyroid Infill, No Supports

• Outer Brim recommended

• Recommend slowing down your acceleration for this print, since it is small and has very
  thin sections on the sides.  Lowering your print temp by 5° may also help improve quality.

Please share any feedback or comments you have.   I'd love to see your Makes too if you don't mind!