That is a case and on/off button protector for the awesome iROAR speaker from CREATIVE.

The case is in two parts, (Coque...droit and Coque...gauche files) that you need to print separately. I advise you to print this part in TPU (1 or 2 wall layers and 20% gyroid infill) for shock absorption although you might print it in PETG or PLA for a rigid case...
Both parts just slide into place without anything else to do. They provide full corner coverage and a little bit of extra thickness on the bottom (to help the speaker cool down as I noticed that the electronics tend to heat up a lot at max volume, as well as provide extra shock and vibration dampening)

I also included a small part (iROAR... allumage) which is extremely useful too if you don't want to print the whole case, it protects the on/off button to avoid the speaker from turning on on it's own all the time when being carried arround. You just need to stick it in place with a little bit of Blue tack/ Pattafix or double sided tape. I advise you to print it in PETG or PLA... though I test printed it in TPU and it added comfort when turning the speaker on and off)

Though it was a hell of a challenge to design the speaker I did it to make sure that the case would fit perfectly, and it does. Even if your printer is not 100% tweaked in, the TPU should bend and stuff and you'll be able to fit it, it's not extremely snug anyway. I added the file too if you want to design a part for the speaker.

PLEASE if you print it, tell me how it fits, how it printed etc...

Pour mes amis Français, n'hésitez pas à utiliser google traduction si tout nn'est pas clair ou à m'envoyer un message :)