Project: Star Wars Stormtrooper 1.hfp
Print with a 100% fill rate, a layer height of 0.08 mm, and a base layer height of 0.16 mm

The model's dimensions are 182.16x200mm.
You can use a higher layer height for printing at a minimum depth of less than 0.48mm.
The maximum depth is 2.2mm, and the actual depth is 2.3mm.

Consumables used:
Bambu Lab Basic Black PLA Transmission Distance: 0.6
Bambu Lab basic blue-grey PLA, transmission distance: 2.5
Jessie Premium gun, metal gray PLA, transmission distance: 4.5
Bambu Lab Basic Ivory White PLA, Transmission Distance: 5
This printer uses four unique consumables

Replacement instructions:
Start with black
Switch to blue-grey at the 9th layer
Switch to gun metal gray at the 14th layer
Switch to jade white at the 20th layer

-------------------------------------------------------------------------------------------------------------------------------

The final result will depend on the consumables used and their transmission distance. If your consumables have very different transmission distances, please adjust the layers in Bambu Studio to achieve the best results.

I hope to be able to upload more models here: https://makerworld.com/@luckyfer/collections/5516891-hueforge

Since I plan to publish a large number of works, for obvious reasons, I can't show the actual printing results in all of them. Therefore, the final appearance may not be exactly the same as the images captured by Hueforge or Bambu Studio.

Thank you for your "like/support".