Summary

The ultimate in laziness- I was tired of using a rod to push out cartridges as I ran them through my Lyman Small Rifle case gauge if they were tight or had lube on them. So I got out the calipers, fired up Fusion 360 and made a base for the case gauge, made a little push button, got a small spring and epoxied the button assembly to the base after making sure the button lined up to the hole. The spring I used is a 9.5mmx19 from an Amazon kit of random springs, it's likely optional as the case would push the button out but you might as well have it. I mainly use it for 223 and 300BO, so you would just glue a button over each slot you would use. Enjoy faster case checking!