AI Dot camera stand
Orivalo22
AI找相似
打印配置(0)
模型文件(0)
0
0
0
发布时间:2025-09-03 16:28:32
0
0
000描述
标签
模型来源
评论(0)
该内容已自动翻译。 显示原文
Overview:
I installed an AI Dot camera next to my CNC and mounted it above and behind the machine. This wasn't ideal for fourth-axis work, as the spindle would always block the view. I created this bracket so I could move the camera to different viewing angles based on the project. I used screws to mount one on the top and back of the machine, and the other was attached to the MASSO controller using double-sided tape. I could simply remove the camera from one bracket and slide it into another one.
It's installed tightly, so the camera won't slide out on its own.
Print:
It can be printed with almost any material, but I only used PLA. If you print in the direction shown, you might not need support, but I still added support to the sharp corners at the bottom. It's very small and adds a bit of stability.
标签
模型来源
原设计地址: 点击查看
CC BY-SA