This is a spezial, optimised holder/stand for a gillette mach 3 razor or similar models. It is designed to be printed in vase mode and it is optimised for wet environments where moisture and water would other get stuck between layers and walls. However: 3D-Printed plasticis is NOT foodsave, no matter which material! I highly recommend keeping the blade, which has skin contact away from the holder. This is why it is small and does not cover up the entire razor.

Printing:

Printing settings are standard 0,2 mm layer hight with 0,4mm nozzle, except for vase mode and 6 bottom layers. Please change these settings, otherwise the print will fail! When printing with a different layer hight, set the number of layers so the hight of the bottom layers is 1,05mm. Keep in mind that the first layer is higher than the others in most cases If your printer has issues with constant high extrusion rates, print slower or at a higher extrusion factor.