Hi,

Decided to upgrade CTC 3D with E3D v6 hotends. It was clear that some kind stepper motor bracket are needed for bowden setup, so I designed my own. Hope you like it.

On T-part, use M3 theat tap to make threat, open holes with 2,5mm drill if needed. For assembly you need also 6pcs M3x12 hex socket screws and 2pcs of nut. Tighten screws of T-part only necessary amount to support motors.

Incase of E3d v6 hotends on CTC, here's cooling duct too: http://www.thingiverse.com/thing:1932246

Extruders on pictures: http://www.thingiverse.com/thing:1359438

E3D v6 CTC 3D mount: http://www.thingiverse.com/thing:1655253

Print Settings

Printer:

CTC 3D

Rafts:

**Supports:**

No

Resolution:

**Infill:**

30%

Category: 3D Printing